WASBAR 60K Puffs

I have run one WASBAR 60K as my own device for six weeks, and before that I spent two days reading five shop listings for it in four languages. What follows is the part those listings leave out: what the specification table means when you hold the device, what a 20 ml reservoir really delivers, what is genuinely in the box and what is not, and how to keep the unit working well for the whole of its life. Everything below is what the maker and this listing state, and where they state nothing I say so instead of filling the gap.

The WASBAR 60K, and how to read its specification table

The WASBAR 60K is the bar-shaped, single-flavour member of the WASPE range. One sealed device carries 20 ml of pre-filled liquid, a built-in 650 mAh cell, a dual mesh coil rated at 1.0 + 1.0 ohm and a full screen colour display. There is no pod to swap and no button to press: you draw on it. Ten flavours, two strengths, 2% and 5%.

The number that matters is the one the shelf label does not explain. At 20 ml this is the leanest reservoir in the WASPE 60K family, and the honest way to plan around it is to forget the headline figure for a moment and look at how much liquid each draw consumes. That is what the next section does.

Form, build and what you actually hold

A bar-shaped body with a fixed mouthpiece and a display that takes most of the front face. It is a pocket device rather than a desk device, and nothing on it needs adjusting before the first draw. The maker does not publish the weight or the outer dimensions, so this listing does not quote them, and you should treat any figure you see elsewhere as belonging to a different model.

What each published figure means in practice

The maker’s figures are the ones below, and the third column is what each of them changes in use rather than a repeat of the number.

Why the reservoir, not the rating, sets the calendar

A sealed device ends when the liquid ends, not when the printed number ends. The cell can be topped up from a socket as often as you like; the 20 ml cannot be refilled at all. That single asymmetry is what decides how long the device lasts you, and it is why the next section counts draws instead of trusting a rating.

What 60,000 puffs works out to from a 20 ml fill

Every listing for this device, including this one, repeats the maker’s rating of up to 60,000 puffs. None of them shows the arithmetic behind it. Divide 20 ml by 60,000 draws and you get roughly 0.0003 ml of liquid per draw, which is far below what published vapour studies measure. Those studies put an experienced adult’s draw at about 0.003 to 0.004 ml, and that figure is per millilitre, so it converts directly to this reservoir rather than being borrowed from a different device.

A figure you can plan a week around

Take 5,000 draws as the working number and your own habit does the rest. At 100 draws a day the device covers roughly seven weeks. At 200 a day it is about four weeks. At 400 a day, which is a heavy habit rather than a typical one, expect around a fortnight. That band is the honest answer to the question every listing dodges, and it is the figure to use if you are deciding how many devices to keep on a shelf or in a drawer.

Where this listing and the maker’s own figure sit

The rating is a manufacturer figure and it is presented here as one. Nothing in this listing is a measured test of a WASBAR 60K, because no independent bench test of this model was found while preparing it. If a longer life is the deciding factor for you, compare the reservoir volumes of the devices you are considering and ignore the ratings until you have: on this family, capacity tracks the honest number far more closely than the printed maximum does.

What is genuinely in the box, and what is not

One box holds one device with the liquid already sealed inside. Nothing needs filling, priming or assembling, and there is no separate pod to keep track of. The rest of this section exists because the two questions that follow a first order are both about absence rather than presence.

What the maker does not state

This listing cannot tell you the device weight, the outer dimensions, whether a charging cable is included in retail packaging, or a stated coil life in draws. None of those appear in the maker’s published specification for this model. If any of them decides your purchase, ask before ordering rather than assuming a figure you have seen on a similar-looking listing, because the listings for the nearest-named sibling carry numbers that do not belong to this device.

The flavour list, and why the last two names are a trap

Ten flavours, all of them pre-filled at one of two strengths. The names are the maker’s own, and they are worth reading carefully: seven of the ten carry an ice or ice-adjacent finish, so a shopper who dislikes a cooling edge has three names to work with rather than ten.

Cherry Cola and Strawberry Ice are not the same flavour

Some listings show a ninth or tenth name as a cherry ice instead of a Cherry Cola, and at least one shows the two names on the same page. They are different liquids. This listing sells other 60,000 puff devices as well, and the naming drift between them is the single most common way an order arrives as something the buyer did not intend. Order by the name as it appears here, and if a page you are comparing shows ten names that do not match this list, it is describing a different fill.

Ten flavours, one device

You are not choosing a flavour for a session, you are choosing it for the entire 20 ml. That makes the decision more like buying a bottle than buying a pod, and it is worth trying a smaller device first if you are unsure. There is no way to change your mind once the fill is open, and no way to split the reservoir between two flavours.

Drawing, charging and the 650 mAh routine

Your first session

Unwrap it, draw on the mouthpiece and it fires. There is no button to hold and no menu to scroll. The display lights on the draw and settles back down afterwards, so the first thing to do is simply watch what it shows you for a few draws and learn where the two level readings sit on a fresh device. Everything after that is comparison against that baseline.

What a 650 mAh cell gives you

A 650 mAh cell in a low-power draw-activated device is a working-day battery rather than a week-long one. Treat roughly 250 to 400 draws per charge as the planning band: a light user will finish a day on one charge, and a heavy user will plug in daily or every other day. The maker does not publish the charging current, so the honest statement is that the shop’s own specification gives roughly half an hour from empty to full, and that the port is Type-C.

How the two readings drift

The liquid percentage is calculated rather than measured. There is no float in a 20 ml sealed tank, so the figure is inferred from draws taken since the fill was opened, which means it can step down unevenly and will not match a laboratory measurement. The charging percentage behaves the other way round: it is read from the cell, so it is close to literal, and the last few percent can sit still for longer than the earlier ones. Plan on the liquid figure being indicative and the charge figure being reliable, and neither of them being a puff counter.

Whether this device is the right one for you

A sealed 20 ml device is an excellent answer to one set of habits and a poor answer to another. Reading the table below is faster than working it out after the first fill.

One habit that decides everything

Count how many draws you take on an ordinary day before you order. Ninety or a hundred a day suits this device well and a single fill will run for weeks. Four hundred a day does not: you would be buying a device a fortnight and charging it most evenings, and a larger reservoir would serve you better even if it costs more. The rating on the front of the box says nothing about which of those two people you are.

WASBAR 60K against the WASPE Bar 60K

Two devices in this catalogue share a brand, a puff rating and almost the same name. They are not the same product, the specification sheets differ in three places, and resellers blur the two constantly. If you have read a review that mentions 36 ml, you have read about the other one.

The check that settles it in one line

Read the reservoir figure first. A listing that says 20 ml is describing this device; a listing that says 34 ml or 36 ml is describing the sibling, however similar the product name looks. The coil rating is the second tell: dual 1.0 + 1.0 ohm here, a single 0.9 ohm there. If a page gives you a 36 ml figure and a 0.9 ohm coil, no part of it is about the device on this page.

Why the search results are full of the other one

A general search for the 60K name returns the sibling far more often than it returns this device, and an AI summary prepared while writing this page answered a question about the WASBAR with the sibling’s reservoir size. That is not a reason to distrust the search engine, it is a reason to read the capacity line on any page before you use its numbers. Everything quoted in this section on the sibling comes from that sibling’s own listings, and nothing from it has been mixed into the tables above.

Keeping one unit working well from the first draw to the last

None of this is repair work, because a sealed device has nothing to repair. It is the handling that decides whether the flavour holds up to the end of the fill and whether the fill lasts as long as the arithmetic in the second section says it should.

Charge it, do not cook it

A 650 mAh cell that is topped up often and never run flat is under less strain than one cycled empty. Plug in when the charge reading drops to roughly a fifth rather than at the moment it cuts out, and take it off the cable once it reads full. Heat is the enemy of both the cell and the liquid: a car dashboard in summer or a radiator shelf will do more damage in an afternoon than a year of ordinary use.

Storage between devices

Keep unopened devices upright, out of direct sun and out of the cold, and keep them sealed until you intend to use them. Once a fill is open, use it: the liquid is exposed to the air through the mouthpiece from the first draw, so a half-used device left in a drawer for months will not taste like a fresh one. If you keep several flavours at home, keep the spares sealed and open one at a time.

Small habits that protect the flavour

Keep the mouthpiece clean with a dry cloth, since pocket lint and dust are the most common cause of a tight, unwilling draw, and wipe the charging port before plugging in. Do not leave a device plugged into a charger overnight on a regular basis, and do not store it lying on the charging port. Draw steadily rather than in short aggressive pulls: long hard draws use more liquid per puff than the working figure in the second section, which shortens the fill.

Questions buyers ask before the first order

Can both strengths be ordered in every flavour?

This listing carries the full flavour list at both 2% and 5%, and the strength is chosen as an option on the product page. If a combination you want is not selectable, that flavour has sold out in that strength rather than never having existed, and it is worth asking before you order something else.

Will the device leak in a bag or a pocket?

There is no fill port and no pod seal to fail, which is where most disposable leaks start. The areas to watch are the mouthpiece, which collects condensation, and the charging port, which should be wiped dry before it is used. Storing it upright with the mouthpiece at the top removes most of the everyday nuisance.

The screen says a fifth is left and it already tastes thin. Why?

The liquid figure is counted from draws taken rather than measured in the tank, and a long draw uses more liquid than the average the count assumes. A heavy or long-draw habit therefore runs the display slightly ahead of the real state, and the flavour thins before the number reaches zero. When taste and number disagree, the taste is the more accurate instrument.

How long can an opened device sit before it is finished?

This listing publishes no shelf life for an opened device, so it does not quote one. What can be said from the design is that a sealed, unopened device keeps far longer than an opened one, so the sensible routine is to open a device when you are ready to use it and to finish it before opening the next.

What decides the colour shown on the display?

The maker publishes no colour scheme for the screen and no mapping between a colour and a level, so this listing does not invent one. The two readings on it are the ones to learn on your own unit during the first few draws.

Does the screen stay lit when the device is not being used?

The maker states a full screen colour display that reports levels; it does not state whether the panel sleeps between draws or how long a reading stays on screen. Expect it to light on the draw and to settle afterwards, and check the first one you open rather than relying on this description for a detail the specification does not cover.

Trade orders: what a box and a carton hold

For shops and resellers, this is the packing detail the maker publishes for the WASBAR 60K. It is here because it is asked for constantly and appears on very few listings. Order quantities, availability and the price for your tier are confirmed with the trade desk rather than quoted on this page, where they would go stale the moment a tier changes.

Before you place a trade order

Confirm the flavour mix, the strength mix and the delivery window with the trade desk in one message, because the maker ships one flavour per inner box and a split order has to be built that way. If you are ordering against a planogram, take the carton dimensions above and check them against your shelf depth first. Devices are sealed and non-returnable once shipped, so the flavour and strength split is the decision worth getting right before dispatch rather than after.